Frame of a metal structure - the modern replacement of wooden slats. Metal profiles are well fastened to the wall, easily cut and joined together. How to work with them almost completely repeats the principle of building framing wall of wooden slats. Tools and materials: 1. Metal profiles. 2. Drill and knock fasteners for attaching strapping to concrete 3. Saw 4. Nails and a hammer 5. Spirit level 6. Chalk cord, pencil Attention! For this work may require permission of local authorities. For advice contact the interdepartmental commission for your district. Process: 1. Before you begin, decide where it will be your partition walls. When planning, make sure that it was lighting, ventilation, electricity and heat. 2. Mark up the future border wall. We stretch the cord and chalk otschelkivaem line markings on the ceiling. From one end of the line we draw on the ceiling with a pencil on the wall with the level or range lines to the floor. Repeat the same on the opposite wall. Trying to drive a nail into the floor at the bottom of each line on the walls. Anchoring nails on the chalk cord and otschelkivaem line markings on the floor as well as on the ceiling. Mark up the border door. 3. Metal profile cut near-wall, ceiling and trim the bottom frame wall. Cut the desired length with scissors for metal. Where there is a doorway in the lower profile, leave the desired interval. 4. Put on the floor of the waist profile and marks its width at the baseboard. Now cut out the marked section of the plinth on both sides, ensuring accurate vertical cut. Remove the cut section of skirting, if necessary, their prying claw hammer. 5. Screw bottom, ceiling and wall profiles with screws to the wall. The interval between the bindings must be no larger than 60 cm If the hardware you need to do to concrete, stone drill, make a hole through the profile, which bude used as anchorage. And it is hammered into it with a dowel fasteners. 5. Insert a wooden block in the profiles around the doorway. This would allow fixing the door frame. Profile with the bar is inserted into the profile of the waist on one side of the doorway. Repeat the same with the other side. 6. Set the profile door lintel. He must have bends at a right angle for attachment to the uprights. Anchoring profile jumpers on the racks with screws for plasterboard. Check the horizontal spirit level. 7. Sets the first rack, as if screwing it into the upper and lower profile frame. When he is inside, turning the profile rack in the desired position. And repeat these steps for the remaining posts, including a rack over an aperture. 8. Install the strut, if they do you need for mounting heavy objects on the wall or for mounting small Lisov drywall. 9. The frame is ready! Now you can sheathe its plasterboard.
No comments:
Post a Comment